I would like to share with your the recipe of making this pair of earrings.
You need to use only simple materials.
2 ear wires
4 4mm round or bicone beads
8 small seed beads
4 head pins
Round nose pliers to make loops!
3. At the other end of the headpin, use your flat nose pliers and bend the head pin approximately 0.5cm from the end to 90 degree. If you are making a bigger loop, you should then bend close to 1cm of the wires.
Place the round nose pliers at the tip of the head pin. Depending of the size of the loop you are making, you should place the headpin at the right place of the round nose pliers as the diameter of the round nose pliers will determine the diameter of your earring loops.
Now, take out the pliers and place it inside the loop as per picture below. Twist the loop backward so that you form a nice circle. Close the loop fully.
Make the other side and you are done.
Feel free to distribute the content of the post. However, you must give credit by providing a link back to http://www.handmade-jewelry-club.com/